Filter
Top Products
EN 33
MAKE CONNECTIONS
1
Connect two sets of SR-TS1U and a TV using AV cables
as shown in the illustration on page 32.
● The mini-plug cable is a mono 3.5 mm mini-plug to
mono 3.5 mm mini-plug connector.
● When playing back S-VHS recordings, it is recom-
mended to use the S-VIDEO connection to minimize
picture degradation.
TURN ON ALL
COMPONENTS
2
After completing the connections, turn on all the
components.
● Set the TV to video input mode or A/V input mode.
Refer to the TV instruction manual.
LOAD CASSETTES
3
Insert the playback cassette into each SR-TS1U.
● Set SR-TS1U–2 to "AUX". Press CH 5∞ to select the
input mode depending on the connector being used –
"L-1" for the rear AUDIO/VIDEO IN connector, or "F-
1" for the front AUDIO/VIDEO IN connector.
START PLAYBACK
4
Press PLAY on either of SR-TS1U.
When the playback reaches to the returning position
(tape end or recording end ੬ pg. 28), the other
SR-TS1U successively starts to play. (The cassette will
automatically be rewound when the playback stops.)
Therefore, the cassettes loaded on two SR-TS1U will be
played back alternately as many times as you want.
STOP PLAYBACK
5
Press STOP/EJECT on the SR-TS1U which is playing
back a cassette.
Using two sets of SR-TS1U, you can play back two cassettes
alternately as many times as you want. You can select the
returning position for Series Playback (੬ pg. 28)
Use the buttons and controls on the VCR‘s front panel for
the Series Playback operations (except when using Mode
Lock).
To prohibit operations during Series
Playback (Mode Lock)
Press and hold OK on the remote control for more than 5
seconds. The Mode Lock indicator lights up on the front display
panel (੬ pg. 66). The 2 cassettes will be played back alter-
nately without any interruption.
To resume the other operations, press and hold OK on the
remote control again for more than 5 seconds.
JOG
SHATTLE
PLAY
CH
STOP/EJECT