Filter
Top Products
EN 35
MAKE CONNECTIONS
1
Connect two sets of SR-TS1U to other equipment, an-
tenna or cable as shown in the illustration on page 34.
● The mini-plug cable is a mono 3.5 mm mini-plug to
mono 3.5 mm mini-plug connector.
● When connecting a camcorder or another VCR with
an S-VIDEO output connector as recording source, it
is recommended to use the S-VIDEO connection to
minimize picture degradation.
TURN ON ALL COMPONENTS
2
After completing the connections, turn on all the
components.
● Set the TV to video input mode or A/V input mode.
Refer to the TV instruction manual.
SET RECORDING VCR’S
INPUT MODE
3
Set to "AUX". Press CH
55
55
5∞ to select the input mode
depending on the connector being used – "L-1" for the
rear AUDIO/VIDEO IN connector, or "F-1" for the front
AUDIO/VIDEO IN connector.
PREPARE FOR RECORDING
4
Insert the recording cassette into each SR-TS1U, and
prepare the playback source.
NOTE:
If you do not want to display the superimposed
indication on the screen during recording, set it to
"OFF" (
੬
pg. 30). If the playback equipment has a
superimpose/OSD disable feature, set its superimpose
or display feature to "OFF" as well.
Using two sets of SR-TS1U, a long recording will be possible
(such as camcorder recording, another VCR playback or TV
broadcast).
Use the buttons and controls on the VCR‘s front display
panel for the Series Playback operations (except when
using Mode Lock).
To prohibit operations during Series
Recording (Mode Lock)
Press and hold OK on the remote control for more than 5
seconds. The Mode Lock indicator lights up on the front display
panel (੬ pg. 66). The picture will be recorded onto the
cassettes alternately without any interruption.
To resume the other operations, press and hold OK on the
remote control again for more than 5 seconds.
NOTES:
●
Series Recording is also possible using the front AUDIO/
VIDEO connectors.
●
When recording a TV broadcast, tune in the same channel on
both SR-TS1U.
●
If you do not want to record the superimposed operational
indications on the screen during Series Recording, set the
Superimpose mode both in playback and recording to "OFF".
(
੬
pg. 30)
JOG
SHATTLE
CH
REC
STOP/EJECT
START RECORDING
5
Press REC on either of SR-TS1U.
When the tape reaches to the end while recording, the
other SR-TS1U successively starts to record. Therefore,
recording will be continued onto cassettes loaded on
two SR-TS1U alternately.
● The cassette will automatically be rewound when the
recording stops.
● Replace the cassette after rewound if you want to
continue to record onto another cassette.
STOP PLAYBACK
6
Press STOP/EJECT on the SR-TS1U which is recording.