Filter
Top Products
EN 7
(MONO)
IN OUT
AUDIO
VIDEO
CH3
CH4
ANTENNA IN
TV OUT
CABLE
BOX
IN OUT
S VIDEO
L
R
VHF/UHF
REMOTE
RF Cable (supplied)
Matching
Transformer
(not supplied)
AC Power
Cord
Audio/Video
Cable
(supplied)
TV
Back of VCR
To Antenna Input
To AC Outlet
Antenna or Cable
Flat Feeder
Coaxial Cable
NOTES:
●
To make the most of the Super VHS picture performance we
recommend that you use the supplied S-VIDEO cable to
connect your VCR to a TV with an S-VIDEO input connector.
●
To operate the VCR with your TV using the S-VIDEO connec-
tion, set your TV to the AV mode using the TV's remote
control.
You can also use the TV/VCR button on the VCR's remote
control to set your TV to the AV mode. (
੬
pg. 56)
S-VIDEO Connection
CONNECT VCR TO TV
a– Connect both the RF cable and the AV cables to the TV as
explained in step 3 of "Basic Connections" (੬ pg. 6).
b– Connect the S-Video cable between the S-VIDEO OUT
jack on the rear of the VCR and the S-Video Input on the
TV.
S-Video Cable
(supplied)
To S Video Input
Connector
Connect the power plug to an
AC outlet
before installing the
lithium battery. (See below)
Installing/Removing the lithium battery
1
Make sure that the power plug is connected to an AC outlet
and turn off the VCR.
2 Open the battery cover while pressing the release tab as
illustrated.
3 Insert a lithium battery with the plus (+) side up and push it
in.
● To remove the lithium battery, press the latch A down-
ward using a pointed non-metallic object, then pull out
the lithium battery.
4 Close the battery cover until it clicks in place.
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
A
To ANTENNA IN
To TV OUT
To AUDIO/
VIDEO OUT
To S VIDEO OUT
To Audio/Video Input