Filter
Top Products
50 EN
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET 1
SCREEN
2
Move the highlight bar (arrow) to "FUNCTION SET 1"
by pressing CH
5
∞ or SHUTTLE PLUS
%
fi, then press
OK or SHUTTLE PLUS
#
.
SELECT AUTO TIMER SET
MODE
3
Move the highlight bar
(arrow) to "AUTO TIMER"
by pressing CH
5
∞ or
SHUTTLE PLUS
%
fi, then
press OK or SHUTTLE
PLUS
#
to set to "ON" or
"OFF".
RETURN TO NORMAL
SCREEN
4
Press MENU.
Auto Timer
When the Auto Timer is set to "ON" the timer is automatically
engaged when the VCR's power is turned off. It is automatically
disengaged when the VCR is powered back on.
Auto SP
→
EP Timer
If, when recording in SP mode, there is not enough tape to record
the entire program, the VCR automatically switches to EP mode to
allow complete recording. This feature is especially handy when
recording a program of more than 2 hours in length.
For Example . . .
Recording a program of 140 minutes in length onto a 120-
minute tape
Make sure you set "AUTO SP→EP TIMER" to “ON” at the
Function screen before the timer recording starts.
Approximately 110 minutes
SP mode
Approximately 30 minutes
EP mode
Total 140 minutes
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET 1
SCREEN
2
Move the highlight bar (arrow) to "FUNCTION SET 1"
by pressing CH
5
∞ or SHUTTLE PLUS
%
fi, then press
OK or SHUTTLE PLUS
#
.
SELECT AUTO SP
→
EP
TIMER SET MODE
3
Move the highlight bar
(arrow) to "AUTO SP→EP
TIMER" by pressing CH
5
∞ or SHUTTLE PLUS
%
fi, then press OK or
SHUTTLE PLUS
#
to set to
"ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
●
If you have programmed the VCR to timer-record 2 or more
programs, the second program and those thereafter may not fit
on the tape if you set the Auto SP
→
EP Timer mode to "ON". In
this case, make sure the mode is not engaged, then set the
tape speed manually during timer programming.
●
In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
●
There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
●
The Auto SP
→
EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will work with the
following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
NOTE:
For safety, when AUTO TIMER is set to “OFF”, all other VCR
functions are disabled while the Timer mode is engaged. To
disengage the timer, press TIMER.
FUNCTION 1
VIDEO CALIBRATION ON
PICTURE CONTROL AUTO
AUTO TIMER OFF
=
AUTO SP=EP TIMER ON
VIDEO STABILIZER OFF
2ND AUDIO RECORD OFF
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
FUNCTION 1
VIDEO CALIBRATION ON
PICTURE CONTROL AUTO
=
AUTO TIMER OFF
AUTO SP
=EP TIMER OFF
VIDEO STABILIZER OFF
2ND AUDIO RECORD OFF
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
TIMER RECORDING (cont.)