Filter
Top Products
69
English
To change the transmittable signals for
operating other manufacturers’ VCR
1
Press and hold VCR .
2
Press VCR.
3
Enter the manufacturer’s code using the
number buttons (1 – 9, 0).
See the table on the right to find the code.
4
Release VCR .
You can always perform the following operation:
VCR Turns on or off the VCR.
After pressing VCR, you can perform the following
operations on a VCR:
1 – 9, 0 Selects the TV channels on a VCR.
For channel number 5, press 5.
For channel number 10, press 1, then 0.
For channel number 23, press 2, then 3.
• TV RETURN will function as the ENTER
button if your equipment requires
pressing ENTER after selecting a channel
number.
3 Starts playing.
1 Rewinds a tape.
¡ Fast-winds a tape.
7 Stops playing.
8 Pauses playing. To release, press 3.
Note:
• Refer also to the manual supplied for your VCR.
5
Try to operate your VCR by pressing VCR .
When your VCR turns on or off, you have entered the
correct code.
If there is more than one code listed for your brand of
VCR, try each one until the correct one is entered.
Manufactures’ codes for VCR
Manufacturer Codes
JVC 01* – 04
Aiwa 05
Akai 06 – 08
Bell & Howell 09
Daewoo 10
Emerson 11 – 15
Fisher 16 – 19
GE 20, 21
Go Video 22, 24, 25
Goldstar 23
Hitachi 20, 26
Magnavox 27 – 29
Mitsubishi 30 – 33
NEC 34, 35
Panasonic 36, 37
Philips 27
RCA 38
Samsung 39 – 41
Sanyo 16 – 19
Scott 42
Sharp 43, 44
Shintom 45
Sony 46 – 51
Symphonic 52
Teknica 53, 54
Toshiba 55
Zenith 56
*
“01” is the initial code.
Note:
• Manufacturers’ codes are subject to change without notice.
If they are changed, this remote control cannot operate the
equipment.
Operating Other Manufacturers’ Equipment
63-74_RX-DV31SL[UW]f.p65 03.4.22, 18:5869