Filter
Top Products
Switching over between Remote Control Command Sets
11
g umschalten
The remote control features 2 command sets, making it possible to operate
2 receivers independently of each other in one room (not together with a twin
receiver).
Note For this purpose, program one receiver on the command set 1 and the second
receiver on the command set 2.
• Switch on receiver 1 and receiver 2 off with the power switch.
⇒ Press and hold the A button.
⇒ Enter "901" with the number buttons.
• To adopt the code, press the e button to switch receiver 1 to standby and
then switch off the device at the power switch.
• Switch on receiver 2.
⇒ Press and hold the A button.
⇒ Enter "902" with the number buttons.
• To adopt the code, press the e button to switch receiver 2 to standby and
then back into operation. Now switch on receiver 1 again.
⇒ Press and hold the A button.
⇒ Enter "903" with the number buttons.
Note When carrying out the first two settings, the remote control must be directed at the
respective receiver (when switched on).
By pressing the A button, you can now switch between the two command sets A
and B (toggle function) and alternately operate both receivers.
Command set 1 is always active as the on-delivery setting.
Note If you are operating only one receiver and the active command set is switched over
by mistake so that this receiver can no longer be operated, the remote control can
be easily switched back to command set 1 by following the procedure described
above.