Filter
Top Products
Installation Menu
38
DiSEqC-setting
The precondition for this setting is that you have made no changes in the DiSEqC
(UFO) setup, refer to the section "DiSEqC (UFO) Setup".
When you are in the LNB configuration menu (see above), press the ou
buttons to move the coloured bar to the "HotBird" position, press the - or + button
and by pressing O confirm that you wish to add a satellite. The transponder data
are now stored and a tick appears after "HotBird" to confirm the setting. You can
now set the DiSEqC signal. It serves the purpose of switching between the two
aligned satellites. Press the ou buttons to go to the DiSEqC-1 setting.
Set #1 for ASTRA and #2 for HotBird. Both positions are already preprogrammed.
Cascade switches can be set under DiSEqC 2. Refer to the instructions for your
receiving system. Factory setting: "---".
Press L 4 times to exit the menu. At the same time, the receiver will confirm that
the set parameters have been saved.
If a setting is incorrect, you will see the following message on the screen: "Bad or
no signal".
Antenna settings
This menu is intended solely for service
purposes and, if need be, i.e. if no
measuring instrument is available, it can
be used to align the antenna (satellite
dish).
The satellite can be defined in the first line
and the transponder in the second.
The polarization of the received signal and
the transmitted symbol rate are shown in
the next line.
The bar displays provide an indication of the strength (relative level) of the signal
and its quality. However, no conclusions relating to the quality of the antenna
system or of the cable connection can be derived from this signal.
Satellite scan
In the satellite scan menu you can instruct the receiver to scan for channels on the
satellite. Use the - or + button to set the required satellite. Start the search scan
by pressing O.