Filter
Top Products
Analogue Settings
45
Decoder
Set the corresponding decoder mode if a decoder is connected to the VCR/AUX
socket. Refer to the operating instructions of the decoder for corresponding
information.
Press the - or + buttons to select the relevant type of modulation
• MAC,
• PAL or
• Canal+.
The factory setting is "OFF".
HDP mode
With HDP mode set to OFF, the receiver will generate a replacement video signal
(blue picture) if no signal is received in analogue mode. This substitute signal must
be switched off as the automatic positioner HDP 160 can evaluate only the video
signal actually received during the automatic satellite scan and setting procedure.
Press buttons - or + to select "ON" or "OFF".
The factory setting is "OFF".
Startprog
Indicates the start channel and therefore the satellite, with which the HDP is to
carry out automatic positioning of the antenna. You can determine the channel by
pressing - or +.
Check the region where you are located and whether the antenna is suitable for
this region before starting the automatic setting procedure of your satellite antenna.
For this purpose, we have provided a leaflet with this User's Guide indicating the
frequencies and footprints of the ASTRA and HotBird satellites as well as Türksat.
Audio menu
Press the M button twice to open the
audio menu. Use the ou buttons
to select the required subpoints.
Audio mode
In audio mode you can select the required sound signal by pressing the - or +
button
• stereo,
• mono left or
• mono right.
The basic setting is "STEREO“.