Filter
Top Products
Safety Information
8
Important information on setting-up location and assembly
Setting-up location
All electronic devices generate heat. The rise in temperature, however, is within a
safe range. Sensitive surfaces of furniture and veneers can over time discolour
slightly due to the constant effects of heat. The feet of the receiver may also
discolour when in contact with treated surfaces. If necessary, place the receiver on
a suitable base.
Ventilation
The heat generated in this receiver is adequately dissipated. Nevertheless, never
install the receiver in a cabinet or on a shelf with insufficient ventilation. Never
cover or close off the cooling slots on the device.
Never place objects on the receiver and maintain a minimum clearance of 10 cm
above the device to ensure the heat is carried off effectively.
Moisture, sunlight, heat
Protect the receiver from moisture, dripping and splash water.
Do not place the receiver near a source of heating and never expose it to direct
sunlight
Mains voltage
Operate the receiver only with a mains voltage of 230 V/50 Hz or connected to a
battery 12 V/24 V DC vehicle electrical system.
First connect the antenna and the television set before connecting the receiver to
the mains power supply and switching on.
Earthing
The parabolic antenna must be earthed according to instructions. Corresponding
local and/or VDE regulations must be observed.