Filter
Top Products
Setting System Parameters
35
Mod.typ
Here you can set the PAL variant corresponding to your TV set.
Refer to the operating manual of your TV set!
The factory setting is PAL-G.
Mod.Ch
In this position you can set the "transmit channel", on which your TV set is to
receive the receiver signal when it is connected to the receiver by means of a
coaxial cable.
In the event of disturbances caused by terrestrial stations, set this channel, while
observing the TV screen, such that the receiver signal is reproduced without
disturbances. Rule of thumb: A spacing of at least one channel should be
maintained between the interference channel and receiver channel.
The factory setting is channel 38 UHF.
OSD colour
Use the -+ buttons to select the background colour of the on-screen displays.
Confirm by pressing L twice
OSD-Trans
Use the -+ buttons to select the transparency of the background colour.
Confirm by pressing L twice