Filter
Top Products
Installation Menu
43
UFO micro system as part of the addressing procedure.
The previously allocated address must be deleted if the receiver is to be used with
different receiving systems. This can be done in the Reset menu point.
The original factory setting is then allocated to the receiver. It must then be reset to
ON. The receiver will then receive a new address from the new system.
The preprogramming is not deleted under "Reset".
Presetting: OFF
Factory setting
Under this menu point, you can reset all the settings to the factory setting by
pressing O.
The factory settings need not necessarily correspond to the settings required for
your system!
After the reset, it may be necessary to repeat all settings.