Filter
Top Products
92
15 OPERATOR CONVENIENCES
MICROPROCESSOR RESET
If your transceiver seems to be malfunctioning,
resetting the microprocessor default settings may
resolve the problem. There are 2 levels of resetting
the microprocessor of the TS-2000(X): partial reset
and full reset.
INITIAL SETTINGS
For each VFO, the factory defaults for the operating
frequency and mode are as follows:
• MAIN VFO A: 14.000.000 MHz/ USB
• MAIN VFO B: 14.000.000 MHz/ USB
• SUB VFO: 144.000.00 MHz/ FM
The Memory channels and Quick Memory channels
have no data stored.
PARTIAL RESET
Perform a Partial Reset if a key or control does not
function according to the instructions in this manual.
The following data is NOT erased by performing a
Partial Reset.
• Memory channel data
• Menu settings
• Antenna tuner preset data
• ANT 1/ANT 2 data
Reset the transceiver by pressing [A/B]+[ ].
• A confirmatin message appears. Press [A/B] to
proceed. Otherwise, press any other key to
cancel the Partial Reset and return to normal
operation.
• “HELLO” appears on the display and the VFOs
resets to the factory default values.
FULL RESET
Perform a Full Reset if you want to erase all the data
in all the memory channels. In addition, this function
resets all the settings that you customized, to the
factory defaults (i.e.- menu settings, antenna tuner
preset data, etc.).
Reset the transceiver by pressing [A=B]+[ ].
A confirmation message appears when performing
the Full Reset. Press [A=B] to proceed. Otherwise,
press any other key to cancel the Full Reset and
return to normal operation.
When you perform the full reset:
• “HELLO” appears on the display.
• All frequencies, modes, memory data and AT
preset data are set to the factory default values
(refer to “INITIAL SETTINGS”, above).