Filter
Top Products
11
206-4207
Upon launching, the Express Script Installer Menu Wizard prompts you to
select a menu mode. Use the Up/Down arrow keys on the Installer Remote
to select the appropriate option:
• Select/highlight Express Script in order to proceed with the Installer
Menu Wizard. Then, press OK (Enter) on the Installer Remote.
• Select/highlight Exit Express Script to exit the Installer Menu Wizard.
Then, press OK (Enter) on the Installer Remote.
1. Select the tuning band.
Use the Left/Right arrow keys to select the appropriate tuning band
(Cable Standard [default], Cable HRC, Cable IRC, or Air). When you
have made your selection, use the arrow keys to select Next, and then
press OK (Enter).
Express Script Installer Menu Wizard
The Express Script Installer Menu Wizard guides you through the process of setting up the essential items for
most hospital TV viewing applications and is displayed each time the TV is turned ON, unless it previously has
been completed or exited.
Note: If previously completed or exited, the Express Script Installer Menu Wizard can be re-activated from
the Installer Menu—set Installer Menu item 117 FACT DEFAULT to 001 to initiate the Express Script Installer
Menu Wizard. See the “Installer Menu” section of this document for further information.
Note: If you plan to create a customized Master TV Setup using the procedure on pages 15 to 18, transfer
(Teach) a Master TV Setup to a Target TV, or congure a TV for FTG Mode of operation, be sure to exit the
Express Script in order to avoid setup conicts that may cause the TV to malfunction.
(Continued on next page)
Which menu mode will you be using?
Installer Menu Wizard
Select Menu Mode
Exit Express Script
OK
PTC: V1.00.013 CPU: V03.07.00.01 ASIC: D279
Express Script
Which tuning band would you like to use?
Installer Menu Wizard
Step 1. Tuning Band
OK
Exit Express Script
Back
Next
F
Exit Script
G
Cable Standard
PTC: V1.00.013 CPU: V03.07.00.01 ASIC: D279
►
►
1
►
2
►
3
►
4
►
5
►
6
►
7
►
8
CC
The following procedure describes the Express Script Installer Menu Wizard. Use the Installer Remote to
make selections and complete each step. You can select the Back button, where available, to check previous
settings, as necessary.
Note: If you opt to exit the Express Script Installer Menu Wizard at any time while it is in
progress, any settings made will not be retained.
Note: If you bypass the Express Script, pillow speaker functionality will not be enabled
unless you set Installer Menu item 027 HOSPITAL MODE appropriately. See the “Installer Menu”
section of this document for further information.