Filter
Top Products
28
206-4207
CHANNEL PREVIEW - BANK 1
CH 011-001 NORMAL-ADDED
Enter -> Change
CC -> VCHIP Menu, Ch. Preview -> Exit
Channel Banks Setup
Channel Banks Overview
Channel Banks enable institution administrators to create tiered channel programming on patient in-room
TVs. Each channel bank may offer a custom channel lineup for a pre-determined fee. LQ630H and
CQ610H TVs are configured with four channel banks, i.e., Channel Banks 1, 2, 3, and 4. The top tier
generally contains the most programming (premium, etc.), 2nd tier = lesser programming, 3rd tier = basic
programming, etc. It is also possible to create an Inactive TV display with Channel Bank 4, so that an
“Inactive TV Call Attendant” message appears when the TV is turned ON. In this case, an administrator
can then select another channel bank on the patient’s in-room TV depending on the programming tier
requested by the patient.
All channels found during Auto Tuning automatically will be “ADDED” to all four channel banks, and the
default is for all channels to be active (NORMAL) in Channel Banks 1, 2, 3, and 4.
Note: Channel banks are not supported on TVs that are congured for FTG Mode operation.
Before You Begin
• Run the Express Script Installer Menu Wizard or complete the Custom Master TV Setup procedure (see
pages 11 to 14 or pages 15 to 18, respectively).
Note: Channel banks can be dened as part of the Express Script Installer Menu Wizard, if desired.
However, if you are setting up channel banks after completing the Express Script or if you are creating a
customized Master TV Setup, use the Channel Preview/Banks Setup Menu as described below.
• Installer Menu item 028 CH. OVERIDE must be set to 001 to allow access for channel banks setup.
Accessing the Channel Preview/Banks Setup Menu
1. To select a channel bank, press BANK on the Installer Remote. The rst time you press the BANK key,
the TV display will show the currently active channel bank. Press BANK repeatedly until the
desired channel bank is selected.
2. After the desired channel bank is selected, press CH PREVIEW on the Installer Remote to display the
Channel Preview/Banks Setup Menu (see below).
Typical Channel
Preview/Banks Setup
Menu
Note: In the Installer Menu, all available Aux inputs are enabled by default. The Aux inputs will appear between
the highest analog and lowest digital channel number in the channel lineup when Channel Up/Down is used
on the Installer Remote. If an Aux input will not be used, it is advisable to disable it. If using the Express
Script, customize the Aux inputs as appropriate in the Aux Input screen (step 2) of the Installer Menu Wizard
before completing the Express Script. If performing the Custom Master TV Setup procedure, refer to Installer
Menu items 035, 039, 087, and 091 before performing the 2-5-5 + MENU operation (step 4). After the TV
setup is transferred to the PTC, the only way to remove Aux inputs from the channel lineup, is to go to the
Channel Preview/Banks Setup Menu and select NORMAL-DELETED.