Filter
Top Products
19
206-4207
Installer Menu
Use the Installer Menu to set up, change, or view operational settings. Refer to the table starting
on the next page for brief descriptions of Installer Menu items. More detailed descriptions follow the
table listing.
Typical Installer Menu
Accessing the Installer Menu
1. Make sure the TV is ON.
2. Using an Installer Remote, press MENU repeatedly until the on-screen
display of the TV setup menus (if the TV is in Pass-through Mode) or the
Function Menu (if the TV is not in Pass-through Mode) no longer toggles,
and then press 9-8-7-6 + OK (Enter) to access the Installer Menu.
The Installer Menu opens with item 000 INSTALLER SEQ 000.
Note: If the password is not entered or registered correctly, you will see
the message “ENTER PASSWORD 0000” at the top of the screen instead
of the Installer Menu header. Once you re-enter the correct password (i.e.,
press 9-8-7-6 + OK [Enter]), the Installer Menu will display.
Note: If the TV is in FTG Mode, the Installer Menu is accessible as read-
only. Refer to pages 41 to 52 for information on FTG Mode configuration.
Using the Installer Menu
Refer to the table on pages 20 and 21 for an overview of the available
Installer Menu items, including their item numbers, functions, value ranges,
and default values.
Installer Menu items not relevant to these TV series are not present in the
Installer Menu; therefore, some numbers are missing. For example, item
006 will not appear. In addition, items that are dependent on other Installer
Menu item settings will not be initially accessible. For example, item 046
STRT AUX SRCE will not display in the Installer Menu unless item 004
STRT CHANNEL is set to 0.
Navigation within the Installer Menu
Use the Up/Down arrow keys on the Installer Remote to sequence through
the available menu items, or access an item directly by keying in the item
number and then pressing MENU. For example, to access the SLEEP
TIMER option, which is item 015, press 0-1-5 + MENU.
Changing Installer Menu Settings
To change an Installer Menu item value, use the Left/Right arrow keys
on the Installer Remote, or enter a valid value directly. To save the new
setting, press OK (Enter), or use the Up/Down arrow keys to navigate to
a new Installer Menu item if you have additional items to edit. Note that
invalid values will not be saved.
xxLQ630H PTC INSTALLER MENU
CPU-CTV
000 INSTALLER SEQ 000
UPN 000-000-000-000 ASIC D279
PTC V1.00.013 CPU V3.07.00
Exiting the Installer Menu and Activating Updates
After you have adjusted all Installer Menu item settings as required, press OK (Enter) once on the Installer
Remote to save your changes; then, press OK (Enter) again to exit the Installer Menu. Any changes you
make will be stored in non-volatile memory.
Note: Each time you exit the Installer Menu in Pass-through Mode, all V-Chip (Parental Control) settings in
the TV are reset to their default values; that is, the Lock System, if previously enabled from the Lock setup
menu (see the Owner’s Manual for additional information), will now be disabled, and the individual Parental
Control settings will be restored to default values.
As part of the Installer Menu header, two
3-character acronyms are displayed to
indicate the TV’s current conguration
mode. The table below lists all possible
mode identiers for these TV models.
Acronym Description
CPU-CTV Pass-through Mode with
Channel Map in CPU
CPU-FTG FTG Mode via CPU
EBL-FTG FTG Mode via EBL
EBL-LNT LodgeNet PPV Mode
MPI-EXT External MPI Control
PTC-CTV Pass-through Mode with
Channel Map in PTC