Filter
Top Products
27
206-4163
Installer Menu
Installer Menu item settings
Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Advanced Control
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Option
Menu Language
Audio Language
Caption
Caption Mode
Digital Caption Options
Lock
Movie Rating
TV Rating – Children
TV Rating – General
Input Block
Time
Auto Clock
Manual Clock
Off Time
On Time
Auto Off (Sleep Timer)
Cloning Overview / Clonable Menu Features
Note: Some menu options vary between analog and digital channels and Aux sources.
Clonable Menu Features
IMPORTANT CLONING INFORMATION
There are three options for cloning a Master TV Setup:
• Using a USB memory device
• Using a TLL-1100A clone programmer
• Using a LT2002 clone programmer
Each option is described in further detail on the pages that
follow. As you perform cloning procedures, be sure to com-
plete each task as indicated. If a procedure or step is omit-
ted or not performed completely, cloning may not work. At
each step, pay attention to ensure the TV screen shows
the proper message when cloning. If the message indicat-
ed does not appear, there is a problem with that step, and
cloning may not be successful.
Warning: Copying a blank or incorrect memory
into a TV will cause the TV to operate erratically
or become inoperable.
Warning: Do not connect a clone programmer to
a PPV card installed in the Master or Target TVs.
Also, if the TV is in LodgeNet PPV Mode (check
with the site administrator if you are not cer-
tain), do not connect a clone programmer to the
GAME CONTROL/MPI port. Either of these
actions will damage the clone programmer and,
if applicable, the PPV card.
Before you begin cloning:
• Complete the Commercial Mode Setup procedure on
pages 12 to 13.
• All equipment should be connected to power and turned
ON.
• Learning and Teaching is only possible between identical
model TVs.
• For both Master and Target TVs—The TV EBL must be in
Pass-through Mode.
• If using a USB memory device, ensure the USB device
has been formatted with FAT format.
• For both Master and Target TVs—If using a clone pro-
grammer, ensure the TV signal source is either an Aux
or TV (RF) source. If a TV (RF) source, the TV must be
tuned to an analog (not a digital) channel.
• LT2002 only—Make sure the batteries in the clone pro-
grammer are fresh. If batteries are removed, the clone
programmer clock time (if set) will be lost (see page 32
for information on the clone programmer clock).
• Do not unplug the TV power cord or remove/disconnect
the USB memory device/clone programmer while Learning
or Teaching, as doing so may cause the TV to malfunction
or harm the USB device/clone programmer, respectively.