Filter
Top Products
EM-C061 Computer User Manual
35
10.1 TOUCH CONTROLLER BOARD
10.1.1 Removal
• Place the computer face-down on a flat surface.
• Remove the 5-pin touch screen flex cable from P3 on the touch controller.
• Remove the serial interface cable from the P2 header on the controller board.
• Remove the 2-pin power cable.
• Remove the 4 Phillips mounting screws holding the controller board to the side panel on the
computer chassis.
• Remove the touch controller from the computer system.
10.1.2 Installation
To install the touch controller, simply reverse the order of the removal procedures specified in the
previous sections.
10.2 MEMORY REMOVAL AND INSTALLATION
Refer to the accompanying SBC User Manual for SIMM removal and installation.
10.2.1 SIMMs Removal
• Place the computer face-down on a flat surface.
• Gently press the retaining clips on each end of the SIMM socket outward until the SIMM comes
loose form the retaining tabs.
Gently pull the SIMM module out of the socket of the motherboard.