(1) Press the [SETUP] button to display the Setup
buttons to select the line of “
Installation “ and press the [ENTER] button
buttons to select the line of
“Auto Installation” and press the [ENTER]
(3) After the channel searching is completed, the
“Please wait” screen will appear a while.
(4) If other stations are positioned on near the
current RF OUTPUT PR, the guide message
The VCR recommends the optimal RF OUTPUT
Press the [ENTER] button to confi rm the
If not, press the [0-9] button to change the
And then, press the [ENTER] button to confi rm. If
you don’t want to exchange, press the [SETUP]
button. (Please refer to the section of “RF
OUTPUT SETUP” on page 25)
(5) The Clock Set screen automatically appears
How to set the clock: See the CLOCK SET
(6) After completing the Auto Searching
procedures, the “Manual Installation” screen
appears. Whenever a channel is searched and
memorized, the PR number will be increased
from 01 to 99 on both LED and OSD.
During channel searching, you can press the
[SETUP] button to interrupt it, then the VCR
goes to the Real Picture.
COUNTRY
Australi
a
New
zealand
ENTER
:Confirm SETUP: End
This function is for you tune your TV to
1. Test Signal Generation Mode
(1) If you use the TV Aerial RF input for the VCR.
In power-on state, press the [ENTER] button for 5
seconds to go to the test signal generation mode.
If press the [ENTER] button for 5 seconds again
or press the [SETUP] button, the real picture will
(2) Tune the TV till it gets the clear test signal,
which has the black and white pattern (2 white
Check whether all the received stations have bad
picture quality due to the interference between the
modulated signal and through signals (general
If there is, adjust the RF output channel on LED or
n LED: “RF 36” is displayed (“RF” is blinking)
and it can be adjusted directly by pressing [0-
9] buttons on remote control.
n SETUP: See the RF OUTPUT SET
This function is for you to search new stations and
(1) Press the [SETUP] button to display the Setup
] buttons to select the line of
“Installation” and press the [ENTER] button to
“Installation” and press the [ENTER] button to
] buttons to select the line
of “Manual Installation” and press the [ENTER]
of “Manual Installation” and press the [ENTER]
] buttons to select the re-
searching channel and press the [ENTER] button
searching channel and press the [ENTER] button
Reception - The list is: AERIAL, CABLE If
aerial is selected, CH is written before the
channel number. If cable is selected, CC is
written before the channel number. If the user
changes the reception: “AUTO SEARCH” is
