Filter
Top Products
14
SWITCHING ON
Take the battery compartment cover off the
back of the Plaza DS•100 remote control by
lifting it up while pushing the catch. Insert the
two AAA batteries supplied, as shown on the
inside of the compartment, and replace the
compartment cover.
Turn your TV set on and choose the correct
channel for the receiver (you usually do this
by pressing an ‘AV’ button on your TV remote
control, but check your TV manual for guidance).
Plug the receiver in and switch it on. After a few
seconds, the set-up screen shown below will
appear on your TV.
HINT: If you do not see this screen on
your TV, see ‘Troubleshooting’ on page
46.