Filter
Top Products
15
The set-up screen shows the strength of the
freesat signal received from the satellite dish.
If the signal strength is below 50%, you should
check the satellite dish connection at the back
of the receiver (switch the receiver off and
reconnect the cable if necessary). If the connection
is OK, consult your dealer or installer.
When the signal strength shown on the set-up
screen is 50% or more, you can tune the receiver
in.
TUNING IN
Because this is the rst time that the receiver
has been used, there are no channels stored
in it’s memory. The receiver will automatically
nd and store channels.
Press the
button on the remote control to
search for the ‘Network ID’ and ‘Transport ID’.
HINT: The Network ID and Transport
ID are in the freesat signal and are
used to allow the receiver to identify
the satellite dish and freesat network,
to make sure the dish is receiving the
correct satellite signals.
When the Network ID and Transport ID have
been found and displayed, press the
button
on the remote control to display the following
postcode screen.