Marantz DV7600 DVD Player User Manual


 
Connecting Up2
12
COAX
OPT
Connecting analog audio cables
Be sure to fully insert each plug for the best
connection. The plugs and jacks are color-
coded to make connection easier.
Connecting optical cables
Optical interconnects
only plug in one way, so
make sure the plug is
correctly lined up with
the jack before insert-
ing. When inserting the
plug, the protective
shutter will open and you should hear it click
into position when fully inserted. Be careful
that you do not force the plug, because this
could result in damage to the
protective shutter, the cable, or the unit
itself.
Home theater audio connections
This player outputs multi-channel audio in
both analog and digital form. Check the
manual for your amplifier/receiver to see
what equipment it is compatible with
(especially which digital formats—Dolby
Digital, DTS, etc.—it can decode).
Important
Before making or changing any rear panel
connections, make sure that all components are
switched off and unplugged from the wall
outlet.
•When connecting the component is turned on,
do not unplug the power cord of this DVD
player from the wall outlet. The speaker may be
damaged.
Connecting coaxial cables
Use an interconnect with a pin-type (also
called RCA or phono)
plug on each end to
connect up digital
coaxial-type jacks.
Make sure that the
plug is pushed fully
home.
Note
If you listen to multichannel DVD-Audio
through one of the digital outputs, it will be
downmixed to stereo. Also, high sampling rate
DVD-Audio (192kHz or 176.4kHz) will be
downsampled to 96kHz, 88.2kHz, 48kHz or
44.1kHz, depending on the disc (see page 40).
Multi channel and high sampling rate DVD-
Audio is only available through the analog
outputs.
All DVD-Audio and all Super Audio CD audio is
output only through the analog outputs (see
pages 41-42).
2
1
4
3
If your amplifier has
stereo inputs only,
connect them here.
Connect to the coaxial or
optical input of your amplifier,
if it has digital inputs.
Plug into a standard
AC wall outlet.
If your amplifier has 5.1 channel analog
inputs, connect them here.
Connect to the L (left)/R (right), SURR.L/
.R (SURROUND L/R), CENTER and SUB
WOOFER inputs of your amplifier.