Filter
Top Products
DVD Setup Menu6
44
Setting up the SP Level Setup
0.0 dB
Rear RS Level
0.0 dB
Rear LS Level
0.0 dB
LFE (Sub Woofer) Level
VIDEO
Off
Front L Level 0.0 dB
0.0 dB
Move : Select : Enter
HDMI DISC SYSTEM
SPEAKER
AUDIO
SP LEVEL
Test Tone
Center
Level
0.0 dB
Front R Level
You may want to make this setting if you connected
this player to your amplifier using the 5.1 channel
analog outputs.
If you want to adjust the relative volume levels of
any of the speakers, adjustment is in the range of -
6dB to +6dB, in steps of 0.5dB.
•When you adjust it, the overall output level may
sound quieter than when Audio out is set to 2
Channel (Stereo, Lt/Rt) or TruSurround. This
is not a malfunction.
To help you gauge the correct gain levels, set the
Te st Tone to Manual (test tone from just that
speaker) or Auto (test tone from each speaker in
turn), then adjust the gain so that all speakers
appear to be the same volume from your listening
position.
Follow the on-screen displays to select speakers
and set the Output Levels.
• Many AV amplifiers allow you to make similar
settings at the amplifier stage. In this case, set
the output levels at the player or the amplifier,
not both.
•As the test tone plays through a speaker, its
name is highlighted in yellow on-screen.
•For the Manual Test Tone procedure, use the
cursor buttons (5/∞) to select the Speaker,
then press the ENTER button to output the
test tone, and once again press the ENTER
button to change the level.
Note
• Te st tone cannot be used if a disc is loaded
press open/close to open the disc tray, and
remove a disc. Be sure to press the open/close
to close the disc tray.
• Change can be made only in the stop mode.
When RESUME is indicated on the display, put
the player in the STOP mode by pressing 7
(STOP) button.
• This setting can be set only Audio Out is set to
5.1 Channel.
Setting up the DISC Setup
VIDEO
English
Subtitle Language English
English
Move : Select : Enter
HDMI DISC SYSTEM
SPEAKER
AUDIO
SP LEVEL
Audio Language
DVD Menu Language
DVD Audio
Player Mode
LANGUAGE settings
If you set the Audio Language, Subtitle
Language and DVD Menu Language in
advance, they will come up automatically
every time you watch a movie.
• Default setting: English
The DVD format recognizes 136 different lan-
guages. Choose Others if you want to specify a
language other than those listed, then follow the
on-screen display to select a language. You may
also want to refer to the Language code list on
page 45.
Tip
You can switch between the languages and subtitle
recorded on a DVD disc any time during playback
using the AUDIO and SUBTITLE buttons. (This
does not affect this setting.)
Note
•You cannot switch languages if there is only one
language recorded on the disc. In this case, the
mark is displayed.
•For some discs, selection can be made using the
DVD menu. In these cases, press MENU to
display the DVD menu screen and then make
your selection.
• If the selected language is not recorded on the
disc, the original pre-recorded language is
selected.