Filter
Top Products
EN 19
Setting DBS receiver input
channel & brand
After installation, set the DBS receiver’s input channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
1
Turn on DBS receiver
Select a channel other than channel 100 or 205
on your DBS receiver.
2
Access Main Menu screen on VCR
Press MENU.
3
Access DBS Receiver Set screen
1 Press
@ #
to move
the arrow to
“TUNER SET UP”,
then press fi or
OK.
2 Press
@ #
to move
the arrow to “DBS
SET UP”, then
press fi or OK.
4
Select DBS receiver input channel
Press %fi to move
the arrow to
“INPUT CH”.
Your selection
depends on how
your DBS receiver
is connected to
your VCR.
● If your DBS receiver is connected to your
VCR’s ANTENNA IN terminal on the rear
panel
Press
@
#
until the channel number
representing the DBS receiver’s output (ON
CH3 or ON CH4) appears on the screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN connectors on the front panel
Press
@
#
until “ON F-1” appears on the
screen.
● If your DBS receiver is connected to your VCR’s
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press
@
#
until “ON L-1” or “ON L-2” appears
on the screen.
● If you do not use a DBS receiver
Press
@
#
until “OFF” appears on the screen.
CONTINUED ON NEXT PAGE \
VCR
TV
CABLE
/DBS
2
3 4
FUNCTION SET UP
INITIAL SET UPTUNER SET UP
THEN PRESS [OK]
DBS SET UP
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
INPUT CH
BRAND
TEST MODE
OFF
40
TUNER SET CABLE SET UP
FUNCTION SET UP
INITIAL SET UPTUNER SET UP
THEN PRESS [OK]
INPUT CH
BRAND
TEST MODE
OFF
40
SELECT WITH ARROW KEYS
SELECT
OK
EXIT
MENU
DBS SET UP
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
MV8300_U1B-EN15-20 4/1/3, 2:37 PM19