Filter
Top Products
74 EN
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Connect the Controller correctly
(੬ pg. 18).
After confirming your DBS receiver’s
input channel number, re-access the
DBS Receiver Set screen and select
the correct number (੬ pg. 19).
Set the correct DBS receiver brand
code (੬ pg. 20).
Make sure the power is on before
timer recording starts.
Set “INPUT CH” to “OFF”
(੬ pg. 16, 19).
Re-perform the Changing VCR Plus+
Setting procedure (੬ pg. 36).
Wait until a space in memory clears,
or cancel unnecessary program
information (੬ pg. 40).
SYMPTOM
7. Satellite channels are not
automatically switched during timer
recording.
8. Timer recording begins as
scheduled, but the channel is
always incorrect.
9. You moved, and now VCR Plus+
system does not work properly.
10.“PROGRAM FULL” is displayed on
the screen.
POSSIBLE CAUSE
● The Controller is not properly
connected to the VCR.
● The input channel selected on the
DBS Receiver Set screen is incorrect.
● The VCR is not set correctly to control
the DBS receiver.
● The DBS receiver is turned off.
● Even though you do not use an
external cable box or DBS receiver,
on the Cable Set Up screen or DBS
Receiver Set screen, “INPUT CH” is
set to “ON”.
● The receivable stations in the new
area are received on different
channels than those in the previous
area.
● All 24 programs of the VCR’s timer
memory are used.
TIMER RECORDING
MV8300_U1B-EN72-88 4/1/3, 2:28 PM74