Filter
Top Products
34 EN
IN F-1
+
1
POWER
TIMER ( )
VCR Plus+
®
Timer
Programing
Timer recording allows you to program the VCR to
automatically record a broadcast at some future time.
Up to 24 timer recording programs can be made using
VCR Plus+ timer programing or Express timer
programing method (੬ pg. 38) as far as a year in
advance.
The VCR Plus+ timer programing system eliminates the
need to input channel, date, start and stop time data
when programing timer recording settings. Simply key in
the PlusCode number for the TV broadcast you wish to
record and the VCR’s timer will be automatically
programed. (The PlusCode programing numbers are the
numbers next to the program in most TV listing.)
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
● The VCR turns on, and the counter is reset,
automatically.
2
Access VCR Plus+ screen
Press PROGRAM on
the Remote.
● The clock must be
set to access the
VCR Plus+ screen.
If you have not set
the clock, the Main
Menu screen
appears after an error message is displayed.
Refer to page 10 for the clock setting
procedure.
3
Enter PlusCode number
Press the appropriate
Number keys to input
the PlusCode number
printed in the TV
listings for the TV
broadcast you wish
to record, then press
OK.
Then;
If the Guide Channel Set screen appears
— go to step 4.
If the VCR Plus+ Program screen appears
— go to step 5.
● To make corrections, press CANCEL and input
the correct PlusCode number.
● If an incorrect PlusCode number or the one for
a broadcast already finished has been inputted,
“PLUSCODE NO. ERROR CONFIRM
PLUSCODE NO. THEN RETRY” is displayed for
about 5 seconds, then the VCR Plus+ screen
reappears.
TIMER RECORDING
VCR
TV
CABLE
/DBS
POWER
6
8
WEEKLYDAILY
BACK
2
5
3
TIMER ( )
3 4
7
TIMER PROGRAM
PRESS [+/–] TO SET EXPRESS PROGRAMMING
PRESS NUMBER KEYS [0-9] OR
START STOPDATE CH
EXIT
PROG.
PLUSCODE NUMBER SET
SET
TIMER PROGRAM
PRESS [+/–] TO SET EXPRESS PROGRAMMING
PRESS NUMBER KEYS [0-9] OR
START STOPDATE CH
EXIT
PROG.
PLUSCODE NUMBER SET
SET
1 2 3 4 5
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
MV8300_U1B-EN34-41 4/1/3, 2:35 PM34