Filter
Top Products
EN 63
JLIP ID Number
Setting
The JLIP (Joint Level Interface Protocol) terminal is used
to connect the VCR to a personal computer or similar
device. By connecting through the JLIP terminals, you
can control the VCR during editing and certain other
operations, from the connected personal computer or
similar device.
When connecting this VCR to another device using the
JLIP terminals, each device must have a different JLIP ID
number.
The JLIP ID number of this VCR is preset to “1” when
shipped from the factory. You can change this number to
any other number between 1 to 99.
To change the JLIP ID number of this VCR, follow the
procedure below.
1
Access Main Menu screen
Press MENU.
2
Select JLIP ID Set Up screen
1 Press
@ #
to move the arrow to “INITIAL SET
UP”, then press fi or OK.
2 Press
@ #
to move the arrow to “OTHER”,
then press fi or OK.
3
Set JLIP ID Number
Press %fi to move
the arrow to
“JLIP ID”.
Press
@ #
to enter the
desired ID number.
4
Return to normal screen
Press MENU.
NOTE:
For further details on the JLIP system, consult your Marantz
authorized dealer or visit our website www.marantz.com.
VCR
TV
CABLE
/DBS
1 4
2 3
FUNCTION SET UP
INITIAL SET UPTUNER SET UP
THEN PRESS [OK]
CLOCK SET
JLIP ID
LINC
RESET NUMBER
1
GUIDE CHANNEL OTHER
SELECT WITH ARROW KEYS
AUTO
SELECT
OK
EXIT
MENU
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
MV8300_U1B-EN53-63 4/1/3, 2:33 PM63