Filter
Top Products
70 EN
MULTI-BRAND REMOTE CONTROL (cont.)
When programed (set) with a manufacturer’s (brand’s)
code, this Remote can perform some of the remote
control functions of the listed DBS (Direct Broadcast
Satellite) receivers.
1
Turn on the DBS receiver
Turn on the DBS receiver using the Power button
on the DBS receiver or its Remote.
2
Set remote operation mode
Set the VCR/TV/CABLE/DBS selector to “CABLE/
DBS”.
3
Enter DBS receiver brand code
Follow the example shown below.
1 Press and hold POWER.
2 Press the Number keys to enter your DBS
receiver’s brand code by referring to the table
below.
3 Press STOP ( 7 ), and release POWER.
● Once you have set the Remote to operate a
DBS receiver, you do not have to set it again
until you replace the Remote’s batteries.
4
Operate DBS receiver
Press one of the following buttons: POWER, TV/
VCR CH +/–, and Number keys.
● For some brands, you must press ENTER after
having pressed the Number keys to enter a
channel number.
● To change the DBS receiver’s channels, press
TV/VCR CH +/– or the Number keys.
● To operate the VCR, set the VCR/TV/CABLE/
DBS selector back to “VCR”.
NOTES:
●
Depending on the type of DBS receiver, some or all functions
cannot be operated using this Remote.
●
It is impossible to control a DBS receiver that does not have a
remote sensor.
●
It's not possible to set the Remote for both your DBS receiver
and a cable box at the same time. You can only set the
Remote to operate one of these units at a time.
DBS BRAND NAME BRAND CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
SONY (DSS) 41
RCA (DSS) 40
(Ex.) To set the Remote to JVC 51:
Release
Hold
down
Press in succession
DBS Receiver
Brand Setting
POWER
JKL
. , ?
STOP
VCR
TV
CABLE
/DBS
2
4
TV/VCR
CH +/–
ENTER
3 - 1,
3
4
3
- 3
3 - 2 4
Number keys
MV8300_U1B-EN64-71 4/1/3, 2:32 PM70