Filter
Top Products
ENGLISH
• In the rare event that NG appears on
the LCD, it means that the remote
controller you are attempting to learn
from uses special signals that cannot
be learned by the Marantz remote
controller.
6. Follow the same procedure to make the
remote controller learn the ten-key ⁄7
operation used by the laser disc player’s
remote controller.
7. Repeat the procedure from step 3 to have
the remote controller learn the signal
codes for the other components such as
TV, VCR, etc.
• If no buttons are pressed for
approximately 1 minute while in the
LEARN mode, the remote controller
automatically returns to the USE mode.
• When programming the function
buttons, first switch to the desired
function, then press the button again.
8. When you have finished programming the
remote controller, use a ballpoint pen or
other sharp point to once again press the
MODE button z to return it to the USE
mode. The LCD displays the USE
indicator, and the newly programmed
codes now can be used.
If FULL is displayed on the LCD
If FULL is displayed on the LCD B when
programming in the LEARN mode, it means
that the memory has become too full to hold
any further codes.
If FULL is displayed no matter how many
times you attempt to enter new codes, it
means that the remote controller cannot
accept any new codes until some of the
previously learned codes are deleted to make
space in the memory. Select unneeded codes
for each of the Jog Dial control m and
Function buttons ,, which show FULL and
delete them from the memory.