Marantz RC1200 Universal Remote User Manual


 
ENGLISH
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING REMOTE
CONTROL RC
1200
POWER
CH
VOL
OKOK
3. Use a ballpoint pen or other sharp point to
press the MODE button z on the
receiving unit to call up the CLONE and
RX displays. CLONE appears at LCD A
and RX at LCD B.
4. Press the OK Cursor button ⁄0 on the receiving
unit.
5. Press the OK Cursor button ⁄0 on the sending
unit. The copying operation is now
commenced.
6. During the copying operation, the bar
displays at LCD C on both units start
moving from left to right. After the entire
bar displays have lighted, the display at
LCD B on the receiving unit changes to
RX OK and the LCD display on the
sending unit changes to TX OK. Copying
is now completed.
Do not touch either of the remote
controllers during the copying
operation. Doing so may cause
copying to fail.
When copying has failed at an interim
point, RX NG will appear on the LCD
display of the receiving unit. Check
steps 1 to 5, and repeat.