Filter
Top Products
ENGLISH
ON
OFF
ON / OFF
SOURCE
MACRO
MODE
LEARNING REMOTE
CONTROL RC
1200
POWER
7. Follow the same procedure to enter “D-
A”. When finished, press the OK Cursor
button ⁄0. Pressing OK permanently fixes
the newly written characters.
Similarly, the function names can be
overwritten by pressing the function buttons.
• Up to 5 characters can be entered in the
function display and command display.
• To rewrite the names of the other items
in the Command Name indicator, use
the Jog Dial m to select the desired
command and repeat from step 5.
8. When you are finished rewriting, use a
ballpoint pen or other sharp point to press the
MODE button z to return the remote
controller to the USE mode. The USE
indicator is displayed on the LCD, and the
newly programmed codes now can be used.
ERASING PROGRAMMED CODES
(Returning to Factory Presets)
Codes that have been programmed into the
memory can be erased in 4 ways: by
button(s), by function(s), by Jog Dial
command, and by erasing all memory
contents.
1. Use a ballpoint pen or other sharp point to
press the MODE button z to switch the
remote controller to the LEARN mode, so
that the LEARN indicator is blinking on
the LCD.
Note:
Erasing of programmed codes is only
possible in the LEARN mode.