Filter
Top Products
TroubleshootingInformationHDMI Control FunctionPlaybackSetupGetting Started Specications
20
ENGLISH
System Requirement
Internet Connection by Broadband Circuit
Modem
Device that connects to the broadband circuit and conducts communications on the Internet.
A type that is integrated with a router is also available.
Router
When using the UD8004, we recommend a router with the following features.
Built-in DHCP (Dynamic Host Conguration Protocol) server.
Function that automatically assigns an IP address on the LAN.
Built-in 100BASE-TX switch (built-in switching hub compatible with speeds upwards of 100 Mbps)
Ethernet cable (CAT-5 or greater recommended)
An Ethernet cable is not included with the UD8004.
For Ethernet cable, we recommend you use shielded straight cable (normal type).
If you use the at type or a non-shielded cable, the noise may adversely affect other devices.
For Internet connection, use an ISP (Internet Service Provider). Ask your local dealer for details.
NOTE
• It is necessary to subscribe to an ISP in order to connect to the Internet. If you already have a
broadband connection, there is no need to subscribe anew.
• The router you can use varies with the ISP. For more information, contact your ISP or PC dealer.
• MARANTZ assumes no responsibility whatsoever for any communication errors or troubles resulting
from customer's network environment or connected devices.
Others
The UD8004 can use the DHCP function to automatically set the network.
With the type of circuit in which network setting is performed manually, when subscribed to a provider,
conduct the setting in accordance with “Network Setup” on the GUI menu (vpage 29).
If you connect the UD8004 to a network without a DHCP function, conduct IP address and other settings
according to “Network Setup” on the GUI menu (vpage 29).
The UD8004 does not support PPPoE. If you subscribe to a circuit that is set with PPPoE, a PPPoE-
compatible router is required.
When setting manually, check the setting contents with the network administrator.
n
n
n
•
•
n
•
•
n
•
•
•
•
•
6. Using BD-LIVE function or updating the software version of UD8004
Connecting the Power Cord
Connect the included power cord to the UD8004, and plug it into an AC outlet.
Power cord
(included)
To household power outlet
(AC 120 V, 60 Hz)
NOTE
Be sure to insert the power plug rmly. Incomplete connection results in noise generation. •
Once Connections are Completed
On the GUI menu, when “Other Setup” – “Auto Power Mode” – “On” (vpage 30), the following states are
maintained for about 30 minutes, and then the power is turned automatically to standby.
Turning the Power On
When power is switched to standby
Either press on the unit, or press on the remote control.
The power indicator lights red.
n
NOTE
During power standby, a slight amount of power is consumed. To totally cut off the power, remove the
power cord from the power outlet.
Press the unit’s or the remote control’s .
The power is turned on, and the STANDBY indicator is turned off.
“LOADING” appears on the display, and disc information is read.
The “NO DISC” message is displayed when a disc is not loaded. b
(UD8004)
(Remote control
unit)
Disc not loaded
Playback has stopped
Stopped due to resume function
•
•
•
Connections