Filter
Top Products
16 Display Module (FX3S-5DM)
163
FX3S Series Programmable Controllers
User's Manual - Hardware Edition
11
Built-in Analog
12
Output Wiring
13
Wiring for
Various Uses
14
Test Run,
Maintenance,
Troubleshooting
15
Other Extension
Units and
Options
16
Display Module
(FX
3S
-5DM)
17
Memory
Cassette
A
Special Devices
(M8000-, D8000-)
B
Instruction List
C
Discontinued
models
16.5 Monitor/Test
3. Test mode operation
Counter (C) 16-bit
The operation is same as the test mode operation of timer (T).
Refer to Subsection 16.5.4 for test mode operation of timer (T).
Counter (C) 32-bit
1) Press the [OK] button on the displayed screen to change the current
value or set value.
The current value or set value blinks while it is being changed.
2) Use the [+] / [-] buttons to change the value as desired.
Press and hold the [+] or [-] button for 1 second or more to increase or decrease the value at high speed.
3) Press the [OK] button to determine the input. At this time, the input data is written to the PLC.
Case of resetting the current value
When the [OK] button is pressed and held for 2 seconds or more while the
current value is being changed, the current value is reset to "0", and the
character "R" and current value "0" start to blink.
Press the [OK] button while "R" and the current value are blinking to write
the current value "0" to the PLC, turn OFF the contact, and return to the
monitor mode.
Changing the current value
Resetting the current value