Filter
Top Products
EN-16
Viewing video images (continued)
To stop projecting:
8. Press the POWER button on the projector or the OFF ( ) button on the remote control.
• A confirmation message is displayed.
• To cancel the procedure, leave the projector for a while or press the MENU button.
9. Press the POWER button on the projector or the OFF ( ) button on the remote control again.
• The lamp goes out and the projector goes into a standby mode. In this standby mode, the POWER indicator
blinks red.
10.Wait about one minute for the POWER indicator to be lit in red steadily.
• During this period of one minute in the standby mode, the intake fan and exhaust fan rotate to cool the
lamp.
• Do not unplug the power cord while the POWER indicator is blinking. Unplugging the power cord immedi-
ately after use may cause a breakdown.
• Though the fan makes loud sounds during cooling, such symptom is not a malfunction.
11.Unplug the power cord from the outlet.
• Cover the lens with the lens cap to protect it from dust.
When projected images are distorted to a trapezoid:
With the control area of the projector:
1. Press the KEYSTONE button on the control area of the projector.
2. Equalize the widths at the top and bottom of the screen by pressing the { or } button on the projector or
the {, } (or +, -) button on the remote control, viewing the screen.
With the INSTALLATION menu:
(See Page 21 for menu setting.)
1. Display the INSTALLATION menu.
2. Select KEYSTONE by pressing the { or } button.
3. Equalize the widths at the top and bottom of the screen by pressing the $ or % button, viewing the screen.
To cancel the menu:
4. Press the MENU button several times.
ON
DVI
PC
COMP
COLOR TEMP
AUTO POSITION
ASPECT
GAMMA
A.P.
C.T.
VIDEO
S-VIDEO
POWER OFF
COMPUTER
DVI-D (HDCP)
COMPONENT
VOLUME
ENTER
MENU
POWER STATUS
POWER button
OFF (
) button
KEYSTONE
INSTALLATION
SVGA60
0
opt.