Filter
Top Products
21
21
Part II: Installation
Connecting a DTV Receiver
Connecting a DTV Receiver
DTV Receiver with RGB Video
Connections
(Figure 1)
1
Connect the outside antenna, cable, or
satellite to ANT, or SATELLITE IN on the
DTV receiver (see your DTV receiver’s
owner’s guide for instructions, and cable
compatibility).
2
Connect the incoming terrestrial antenna,
or cable (not satellite) to ANT-A on the
TV back panel (a coaxial splitter, avail-
able at most electronic supply stores,
may be required to complete this instal-
lation).
Connect the RGB cables from the
DTV receiver to the HIGH RESOLU-
TION INPUT GRBHV on the TV back
panel. You may need to set the DTV
input assignment to RGB in the Assign
Input menu, page 33.
DTV Receiver TV Back Panel
3
G (green) = Y/G
4
R (red) = Pr/R
5
B (blue) = Pb/B
If the DTV receiver has outputs for H
and V sync, connect as listed below
(DO NOT connect if DTV receiver uses
“Sync on Green”):
6
H (horizontal sync) = H
7
V (vertical sync) = V
8
Connect the L (left) and R (right) audio
cables from the DTV receiver and to
DTV AUDIO on the TV back panel.
To utilize the bene ts of a digi tal A/V
receiver, connect your DTV receiver’s
digital audio out to a digital input on your
digital A/V receiver.
Figure 1. Connecting the DTV receiver with RGB video
connections.
Y
G
Pb
B
Pr
R
V
H
HIGH RESOLUTION INPUT
INPUT
3 PIP
S-VIDEO
VGA
640X480, 60HZ
COMPONENT 480i /480p
1 (YPrPb)
2 (YPrPb)
DTV (YPrPb/GRBHV)
480i /480p /1080i
VIDEO
MONITOR
IR EMITTER HOME THEATER
21
STB
OUTPUT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
AUDIO-
LEFT/
(MONO)
AUDIO-
RIGHT
ANT-BLOOP OUTANT-A
AUDIO
L
R
H
V
G
R
B
S-VIDEO
VCR
CONTROL
DIGITAL
AUDIO OUT
PHONE JACK
RF
REMOTE
SATELLITE IN
IN FROM ANT
OUT TO TV
CH 3
CH 4
CAUTION
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
White
Red
4
3
5
6
7
6
7
8
8
8
8
3
4
5
TV back panel
2
Incoming Antenna,
or Cable.
2
See Appendix B, page 61, for RGB video
signal compatibility information.
For digital audio connections, see your
DTV receiver and A/V receiver Owner’s
Guides.