Filter
Top Products
29
29
System 4 is designed for use with A/V receiv-
ers that have at least 4 inputs. A/V receivers
with fewer may be only partially compatible.
Part III: Setup
Activating the System 4 Home Theater IR Control
Programming the Remote Control:
To Activate the System 4 Home Theater IR Control
Testing System 4 for Proper Setup
1
Move the slide switch to the position you
wish to test.
2
Point the remote at the TV.
3
Press and release the HOME THEATER
button. If the audio portion has been
properly setup, your A/V receiver will
have changed to the appropriate input
as indicated in table 1, page 15. If the
video connection of your System 4 has
been properly setup, your TV will have
changed to the appropriate input.
AUDIO
If the A/V Receiver did not change
inputs...
1
Repeat Special Setups, page 15, and retest.
2
Reposition IR emitter(s) and retest
3
Repeat To Activate the Audio Portion, page 28,
and retest.
If your A/V receiver is still not responding
to the commands from your remote control,
you may have an incompatible A/V receiver.
Proceed to Deactivating the System 4 Home
Theater IR Control, on this page.
AUDIO
If the A/V Receiver changed to
an input other than the one indicated in
table 1, page 15...
1
Connect the audio output from your A/V
device to the A/V receiver input that your A/V
receiver DID change to, and retest.
VIDEO
If the TV did not change inputs...
1
Repeat To Activate the Video Portion, page 28,
and retest.
Deactivating the System 4 Home
Theater IR Control
1
Simultaneously press the CANCEL
button and the HOME THEATER button.
2
Repeat To Activate the Video Portion,
page 28.