Mitsubishi Electronics WS-55908 Projection Television User Manual


 
33
33
Part III: Setup
Setup Menu: Memorize Channels, Assign Input, and Language
Memorize Channels
(Figure 1)
This selection memorizes the channels your
TV can receive and skips the unused or
weak channels. You can stop memorization
at any time by pressing CANCEL. Channels
memorized prior to pressing CANCEL will
stay in memory. After channels are memo-
rized, you may select memorized channels
in ascending or descending order by press-
ing the CHANNEL button on the remote con-
trol.
Memorize Channels, Assign Input, and Language
Figure 1. Memorize Channels
Assign Input Menu
(Figure 2)
Assign Input turns off unused inputs, turns
them on again, or changes the name of the
input. If you turn an input Off, it will be
skipped when you press the INPUT button
on the remote control. Your choices are:
Ant-A, and Ant-B: On or Off.
DTV: YPrPb, RGB, or Off.
Input: Cycle through the available inputs
(Inputs 1-4, Component inputs 1-2, STB, and VGA).
Status: Turn the selected input On or Off.
Name: Name the selected input
(VGA input cannot be named).
DTV Note: If you have a DTV receiver
connected, you will need to use that
receiver’s channel memorization system
to memorize digital channels.
Figure 2. Assign Input menu
Language
(Figure 3)
Display the on-screen menus in either
English or Spanish (Español). The rst
time your TV was powered on, you were
requested to select an on-screen menu lan-
guage. You may change your selection by
pressing the ADJUST or button on the
remote control.
Figure 3. Language