Filter
Top Products
44
Event/Alarm Limit: Selects the high-limit numbers for events/alarms in 256, 512 or 1024.
LCD:
Screensaver: To prolong the life of the LCD display, it is suggested to set the display turn-
off time in 1, 10, 20, 30, 40, 50 or 60 minutes after the recorder is operated. The recorder
continues to read data while it is in the Screen Saving mode. The display turns on again by
pressing any soft key. When an alarm occurs, it turns on the display as well. It was initially
set for 10 minutes for Screensaver from the factory.
IR detector: Enables the infrared technology on recorder is an innovative idea to prolong
the lifetime of LCD display. The Infrared detector works with the Screensaver to protect the
LCD. The Infrared detector senses the movement of body temperature when a user gets
closer or walks away. (Range approximately 2 meters). Operation is as follows: Set the IR
Sensor to On and Screensaver at 1 Min. Display will turnoff in 1 minute after the user walks
away from the recorder. Once the Infrared detector senses heat movement within 2m of the
recorder, display turns on straight away, without needing to press any key on the recorder.
Note:
IR( Infrared ) detector needs to work together with Screensaver, it cannot function alone.
However, the Screensaver can function alone after the IR Sensor is disabled.
Communication
PCTransfer: Selects RS-232, RS-485, or standard Ethernet communication.
RS-232, RS-485:
Address: 0 to 31 nodes for RS-485
BaudRate: Selected from various Baud rates 1200, 2400, 4800, 9600, 19200 or 38400.
DataFormat: Selected from one of four data formats.
Ethernet:
IP: Select Automation if the server on the network automatically allocates the IP address for
the recorder. Select User Define to manually set a fixed address for the recorder. Two
columns will appear for keying in fixed addresses
IP Address: Defines the correct address of the recorder on the network
SubnetMask: Defines the correct SubnetMask address on the network
DefaultGateway: The Gateway IP address on Ethernet.
Note:
▲ If Automation is selected, the IP address and SubnetMask are invisible. IP address can be
found in 4.6 System Info mode under Configuration. Because IP address might be
reallocated with new address by the server after power off and on, the user defining fixed
addresses is recommended.