Filter
Top Products
12
2. Press FAVonce.
• If FavoriteChannelScanhasbeensetup,scanningof
favoritechannelswillstartwithupto100channelchanges
oruntilstoppedbypressinganykey.
• If FavoriteChannel Scanhas not been set up,scanning
will start with the current channel,and continue up to
100channelchangesoruntilstoppedbypressinganykey.
3. Tostopscanning channels at any time,press any key
once.
PROGRAMMING FAVORITE CHANNEL SCAN
Inthe CBL/SAT or TV mode,you can store a list of up to 10 favorite channels,
in any order,that willbe immediately scannedwhenFAVis pressed (see
UsingChannelScan on theprevious page).
NOTE:Favoritechannelscanonlybeprogrammedforonemode.Afterprogramming,ifFAV
ispressedwhileinanothermode,theremotecontrolwillstartscanningallchannelsinstead
(ifapplicabletotheselecteddevice).
1. On theremote control,press CBL/SATor TVonce.
2. Press and hold
SETuntil the LED (red light) blinks twice,
then release SET.
3. Enter
9 - 9 -6.The LEDwill blinktwice.
4. Use the keypad to enter a favorite channel number(e.g.,
031).Then pressSET once.
NOTE:If theoriginalremotecontrolrequiredpressinganEnterkey
tochangethechannel,alsopresstheENTERkeyafterthechannel
number(e.g.,0 - 3 -1 - ENTER).Onsomesatellitereceiversandcable
boxes,youmayneedtopresstheSELECT(OK)keyinsteadofENTER.
5. If desired,repeat step 4for eachchannel to bestored,up
toa totalof 10 channels.
NOTE:If youtryenteringmorethan10 channels,theremotecontrol
willautomaticallyexitprogramming.Tochangeyourfavoritechan-
nellistatthispoint,youwillfirstneedtodeletetheexistinglistby
performingthestepsin“ClearingCustomProgramming”onpage14.
Then,performtheinstructionsin thissectiononceagain.
6. Toexit programming with less than 10 favoritechannels
stored,pressand hold
SETuntil the LED blinks twice.
Otherwise,the remote control willautomatically exit the
program after 10 channels havebeen stored.
URC4021 manual new IC:CTGAE4P 4021 manual booklet New IC 4/13/09 3:38 PM Page 12