Filter
Top Products
14
2. Enter9 - 9 - 3 and then press VOL▲ once.TheLED will
blinkfour times.
3. Volume will again be independentlycontrolled according
toits default statesfor allprogrammeddevices.
CLEARING CUSTOM PROGRAMMING
The One ForAll 4 Device Universal Remote Control contains anOperational
FeatureReset
program.
If desired,you can use it to clear custom programming,exceptyoursetup
codes and reassigned device keys,and resetthemto originalfactory set-
tings.Alsosee
RestoringFactory DefaultSettingsas below.
IMPORTANT:Executingthis program willerase allyourcustom settingsfor
PowerMacro,Favorite Channels,andVolumeLock.
1. Press and hold SET until theLED (red light)blinks twice,
then release SET.
2. Enter
9 - 8 -0.The LEDwill blinktwice.The remote control
will return to normal operation.
RESTORING FACTORY DEFAULT SETTINGS
The One ForAll 4 Device Universal Remote Control alsocontainsa Factory
Reset
program that you can useto resetall custom settings and setup codes
tooriginalfactory settings.Alsosee ClearingCustomProgramming as above.
IMPORTANT:Executingthis program willerase allyourcustom settingsfor
PowerMacro,Favorite Channels,VolumeLock,ReassignedDevices,andall
devicesettings.
1. Press and hold SET until theLED (red light)blinks twice,
then release
SET.
2. Enter
9 - 8 -1.The LEDwill blinktwice.The remote control
will return to normal operation.
URC4021 manual new IC:CTGAE4P 4021 manual booklet New IC 4/13/09 3:38 PM Page 14