Filter
Top Products
LCD
After MOSAIC has been used a while,a soft key may no longer produce a response when you tap
inside a key’s boundary,yet it still works when you tap outside it.To compensate for this drift,
MOSAIC includes a utility program that you can use to align the LCD back to factory specifications.
1. On the Device Screen in the upper left corner,tap on Setup.You will see the main SETUP Menu
that greets you and asks,“What would you like to configure?”
NOTE: If the LCD is so misaligned,if by tapping on Setup you do not see the main SETUP
Menu,skip steps 1 through 3 and instead press the CH–,MUTE, and VOL + hard keys,all at
the same time.This will cause MOSAIC to go directly to the LCD Alignment Menu.Then start
with step 4 on the next page.
2. Tap on the SYSTEM key.You will see the SYSTEM Menu.
NOTE: To return to a previous menu, tap on the ESC key. To return to last-displayed Device
Screen, press down on ESC or MUTE for at least 2 seconds.For help, tap the ? key.
3. Tap on the LCD key.You will see the LCD Alignment Menu.Following the instructions,tap on
the X on each of the three screens shown below.When the procedure is complete,the LCD will
be aligned and MOSAIC will return to the System Menu.
NOTE: To cancel the procedure at anytime, press the MUTE key.
X
<
---
Press here
Touch Screen Alignment
Press the MUTE key to
cancel this function.
Tap on
Press here
---
>
X
Touch Screen Alignment
Press the MUTE key to
cancel this function.
Tap on
LCD
UPGRADE
SOUND ON/OFF
LOCK SETTINGS
USER RESET
LANGUAGE
ABOUT
SYSTEM
Welcome to System Setup!
What action
would you like to perform?
Esc ?
Tap on
LCD
UPGRADE
SOUND ON/OFF
LOCK SETTINGS
USER RESET
LANGUAGE
ABOUT
SYSTEM
Welcome to System Setup!
What action
would you like to perform?
Esc ?
To test alignment
Press here
---
>
X
Tap on
www.oneforall.com 37