E-60 E-120 E-180 E-240
VIDEO CASSETTE
This TV/VCR will operate with any cassette that has the VHS mark. For best results, we recommend the use of
high-quality tapes. Do not use poor quality or damaged tapes.
PRECAUTIONS
INSERTING A CASSETTE
Avoid moisture. Moisture condensation may occur
on the tape if it is moved from a cold place to a warm
place. Before using a tape with these conditions, to
avoid a damage of the tape and your TV/VCR, wait
until the tape has warmed to room temperature and
the moisture has evaporated.
Avoid extreme heat, high humidity and magnetic
fields.
Do not tamper with the cassette mechanism.
Do not touch the tape with your fingers.
Insert the cassette in the direction as shown. Push in
gently, but continuously, on the centre-back of the
cassette until it is drawn into the TV/VCR.
The TV/VCR will automatically turn on.
TWO DIFFERENT TAPE SPEEDS
REMOVING A CASSETTE
Before recording, select the tape speed from : SP mode
(Standard Play) or LP mode (Long Play).
The table below shows the maximum recording/
playback time using E-60, E-120, E-l80 or E-240 tapes
in each mode.
1) In the Stop mode, press EJECT button on the remote
control or press STOP/EJECT button on the
TV/VCR. The cassette will eject.
2) Pull the cassette out of the cassette compartment.
3) Store the cassette in its case as shown.
Tape Speed Recording/Playback Time
SP mode 1 hour 2 hours 3 hours 4 hours
LP mode 2 hours 4 hours 6 hours 8 hours
ERASE PREVENTION
You can prevent accidental
erasing of recording by
breaking off the tab on the
back edge of the cassette.
Tab
If you decide to record on
the tape again, cover the
hole with a plastic tape
Transparent Tape
5
Type of
tape
.
.
.
.
WRONG
CORRECT
Window