Filter
Top Products
Recording
Set the accidental erasure prevention tab on the cassette tape to the “recording”
position and insert the tape.
Press the STOP button to place the unit in the stop mode.
Set the TAPE/EE switch to EE.
EE images now appear on the TV monitor.
Check that the REC INHIBIT lamp is off.
If this lamp is lighted, set the REC INHIBIT switch to OFF.
Select the video and audio input signals and adjust their levels.
5-1
Selecting video/audio input signals
1
Connect the signals to be recorded.
2
Select the input signals using the INPUT SELECT switches on the front panel.
The input signals corresponding to the lighted lamps have been selected.
5-2
Adjusting the video level
1
Normally, the VIDEO IN LEVEL control/switch
setting (unity value).
is left at the “PRESET”
2
To adjust the recording level, set the VIDEO IN LEVEL control/switch
to
“MANUAL” and use it to adjust the level to a setting between +3 dB and -3 dB.
5-3
Adjusting the audio level
1
Adjust the audio input signal levels of the analog audio CH1/CH2, CH3/CH4
signals and analog cue signal. Keep the audio input/output level controls
pushed in (unity value).
The audio signals will be recorded at the proper level.
2
To adjust the recording level, pull out the controls
and adjust them. With the
CUE signal, adjust the control in such a way that -20dB will not be exceeded.
Press the PLAY button while holding down the REC button. The REC and PLAY lamps
light, and recording commences.
To end the recording, press the STOP button.
Recording is ended, and the unit goes into the stop mode.
<Notes>
Check that the SERVO lamp is lighted during recording. If it flashes or if it is off, the images
played back will be disturbed.
Only the analog composite video input signals can be adjusted. (The digital video and
analog component input signals cannot be adjusted.)
-26-