Filter
Top Products
Applies only to
AJ-PD950.
INPUT SELECT switches
These are used to select the video and audio input signals.
<Video>
Each time the VIDEO button is pressed, the input video signal selection is switched in the
order of Y/P
B
/P
R
, COMPOSITE, SDTI (V&A), SDI and then back to Y/P
B
/P
R
. When SDTI
(V&A) is selected, both video input and audio input are switched to SDTI.
<Audio>
Each time the AUDIO button is pressed, the input audio signal selection is switched in the
order of ANALOG, AES/EBU, USER SET, SDI and then back to ANALOG. USER SET is a
feature for independently selecting the input signals to record on PCM audio signal
channels 1 through 4, and is used together with the setup menu. However, when video
input is set to SDTI, audio input is also forcibly set to SDTI. For instance, if USER SET is
selected by INPUT SELECT and the channel selections are CH1=ANALOG on setup
menu No. 715, CH2=DIGlTAL on No. 716, CH2=AES on No. 719, CH3=DIGlTAL on No.
717, CH3=SIF on No. 720, and CH4=ANALOG on No. 718, then analog input signals are
recorded on PCM audio signal CH1 on the tape, AES/EBU digital signals on CH2, SDI
input digital signals on CH3, and analog input signals on CH4.
INPUT SELECT display
The characters corresponding to the selected input signal light up.
With the exception of analog audio signals, the display flashes to alert the user when the
selected input signal is not supplied.
<Video>
Y PB PR:
Analog component video signal
CMPST:
Analog composite video signal
SDTI (V&A):
Compressed data serial digital video/audio signal (optional)
SDI:
Serial digital video signal (SMPTE259M-C, 272M, 294M*)
(The entire display lights when signal generation using the internal signal generator has
been selected for setup menu No. 600 (INT SG).)
<Audio>
ANALOG:
Analog audio signal
AES/EBU:
Digital audio signal
USER SET:
Selection of the audio signal to record
SDI:
Serial digital audio signal
(The entire display lights when signal generation using the internal signal generator has
been selected for setup menu No. 700 (INT SG).)
Cassette insertion slot
EJECT button
When this is pressed, the tape is unloaded and several seconds later the cassette is
automatically ejected. When the counter display indicates “CTL”, the display is reset.
Channel condition lamps
One of these lamps lights in accordance with the error rate status. (Green
Amber
Red)
Green:
This lights when the error rates for the video and audio playback signals are both
acceptable.
Amber:
This lights when the error rate for the video or audio playback signals has
deteriorated.
Red:
The playback picture will remain normal even when this lamp lights.
This lights when the video or audio signals are subject to rectification or
interpolation.
AUTO OFF lamp
This lights when trouble has arisen in the decks operation.
-7-