Panasonic AJ-PD950 VCR User Manual


 
USER menu
<TIME CODE>
(continued)
Item
Setting
Superimposed
Superimposed
No.
No.
display
display
502 VITC
POS-2
525 mode
0000
0008
0010
625 mode
0000
0006
0014
0000
0001
0002
10L
503TCG
REGEN
504 REGEN
MODE
505
EXT TC 0000
LTC
SEL
0001
VITC
506
BINARY
GP
507
PHASE
CORR
508
TCG CF
FLAG
509
DF MODE
510
TC OUT
REF
18L
2OL
7L
13L
21L
TC&UB
TC
UB
0000 AS&IN
0001
ASSEM
0002 INSRT
0003
SW
0000 000
0001
001
0002 010
0003
011
0004
100
0005 101
0006 110
0007
111
0000
0001
0000
0001
0000
0001
0000
0001
OFF
ON
OFF
ON
DF
NDF
V OUT
TC IN
Description
This sets the position where the VITC signal is to be inserted.
(The same line as for VITC POS-1 in 501 cannot be selected.)
This selects the signal to be regenerated when the time code
generator (TCG) in the REGEN mode.
0: Roth the time code and user bit are regenerated.
1: Only the time code is regenerated.
2: Only the user bit is regenerated.
This selects whether the time code is to be regenerated during
automatic editing using the units control panel.
0: Time code is regenerated with assemble or insert editing.
1: Time code is regenerated with assemble editing.
2: Time code is regenerated with insert editing.
3: Setting complies with REGEN/PRESET switch setting.
This selects the time code to be used when an external time
code is to be used.
0: The LTC of the TIME CODE IN connector is used.
1: The video signal VITC is used.
This sets the usage status of the user bit of the time code
generated by the TCG.
0: NOT SPECIFIED (character set not specified)
1: ISO CHARACTER (8 bits character set based on ISO646,
1502022)
2: UNASSIGNED 1 (undefined)
3: UNASSIGNED 2 (undefined)
4: UNASSIGNED 3 (undefined)
5: PAGE/LINE
6: UNASSIGNED 4 (undefined)
7: UNASSIGNED 5 (undefined)
This selects whether to control the phase correction of the
LTC generated by the TCG.
0: Phase correction control is not performed.
1: Phase correction control is performed.
This selects whether the CF flag of the TCG is to ON.
0: CF flag is OFF.
1: CF flag is ON.
This selects the DF/NDF mode for CTL and TCG.
0: Drop frame mode.
1: Non-drop frame mode.
<Notes>
.
No. 509 is valid when the CONTROL is LOCAL or LOCAL
ENA of item 004 to ENA.
.
This setup menu is not displayed in the 625 mode.
This is used to switch the phase of the time code, which is
output from the TIME CODE OUT connector, for the external
LTC input when the TC INT/EXT switch is at the EXT position.
(In EE mode only)
0: Time code is synchronized with output video signal.
1: Time code is synchronized with external time code input.
The underline on the setting item denotes the initial setting.
-55-