Filter
Top Products
Checking the edit points
Press the IN (or OUT) button to check the edit point.
The value of the entered edit point appears on the display.
Press the PREROLL button while holding down the IN (or OUT) button to check the
image at the edit point.
The tape is cued at the edit IN (or OUT) point, and the still picture mode at that point is
displayed.
The EE mode is established if the TAPE/EE switch has been set to the “EE” position
when “STOP” has been selected for the setup menu No. 315 (AFTER CUE-UP).
Press the IN and OUT buttons together to check the edit duration.
The duration time appears on the display.
Calculating the duration
When both edit points have been set, the duration between the two edit points.
When only one edit point has been set, the duration between the set data and the current
tape address.
When neither edit point has been set, the duration of the previously edited interval.
2 1,3
- 35 -