Filter
Top Products
Counter display
Monitor display
REEL DIR UNMATCH
REEL DIR UNMATCH
REEL TENSION ERROR
REEL TENSION ERROR
SERVO COMM ERROR
SERVO COMM ERROR
SERVO CONTROL
SERVO CONTROL
ERROR
ERR
SERVO ERROR
SERVO ERROR
S-FF/REW TIMEOVER
S-FF/REW TIMEOVER
S REEL ROTA TOO S REEL TOO FAST
FAST
S REEL TORQUE
S REEL TORQUE
ERROR
ERR
T REEL ROTA TOO
T REEL TOO FAST
FAST
T REEL TORQUE
T REEL TORQUE
ERROR
ERR
UNLOAD ERROR
UNLOAD ERROR
WINDUP ERROR
WINDUP ERROR
WINDUP REEL NOT
ROTA
W-UP REEL NOT ROTA
Description
VTR operation
(Restart condition)
If the reel motor at the take-up side is running in the
reverse direction, the AUTO OFF lamp lights, and the
STOP
message display flashes.
(POWER OFF
ON)
If an abnormal tension at the supply side is detected
STOP
in the reel mode, the AUTO OFF lamp lights, and the
message display flashes.
(POWER OFF ON)
When the servo microcomputer does not follow the
instructions of the system control microcomputer even
STOP
when 10 seconds have elapsed, the AUTO OFF lamp
(POWER OFF
ON)
lights, and the message display flashes.
When there is no response from the servo micro-
STOP
computer for 1 or more seconds, the AUTO OFF
lamp lights, and the message display flashes.
(POWER OFF
ON)
When only the servo microcomputer was reset in an
STOP
instantaneous power failure, the AUTO OFF lamp
lights, and the message display flashes.
(POWER OFF
ON)
If the start/end processing operation is not completed,
STOP
the AUTO OFF lamp lights, and the message display
(POWER OFF
ON)
flashes.
If the supply reel motor should rotate at an abnormally
STOP
fast rate, the AUTO OFF lamp lights, and the message
display flashes.
(POWER OFF
ON)
If
an abnormal torque applied to the supply reel motor
is detected or if an abnormal current flowing to the
STOP
current-sensing resistor is detected, the AUTO OFF
(POWER OFF
ON)
lamp lights, and the message display flashes.
If the take-up reel motor should rotate at an ab-
STOP
normally fast rate, the AUTO OFF lamp lights, and
the message display flashes.
(POWER OFF
ON)
If an abnormal torque applied to the take-up reef
STOP
motor is detected, the AUTO OFF lamp lights, and
the message display flashes.
(POWER OFF
ON)
If the tape has not been wound up during unloading,
STOP
the AUTO OFF lamp lights, and the message display
flashes.
(POWER OFF
ON)
If, after the total tape amount has been detected, the
amount of tape wound up on the take-up reel and the
amount of tape supplied by the supply reel differ to an
STOP
abnormal extent while the tape is traveling in the
(POWER OFF
ON)
forward or reverse direction, the AUTO OFF lamp
lights, and the message display flashes.
If, after the cassette has been inserted, the tape take-
up reel has not wound up the tape while the total tape
STOP
amount is not detected and while the tape is traveling
in the forward or reverse direction, the AUTO OFF
(POWER OFF
ON)
lamp lights, and the message display flashes.
-75-