Filter
Top Products
19
Operation
Repeat playback
Setting the BEGIN and END points Setting the repeat playback mode
Set the VTR to the menu mode.
(This is done by setting the LOCAL/MENU/
REMOTE switch to the MENU position).
1
Set the VTR to the menu mode.
(This is done by setting the LOCAL/MENU/
REMOTE switch to the MENU position).
1
Select menu item No.160 [MEMORY MODE],
and select the repeat playback mode.
2
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
3
<Notes>
O The image will deteriorate if the same tape is
played back over and over again. Once a tape has
been played back for a hundred or so times,
replace it with a new one.
O The image which is to be output when the tape is
returned to the BEGIN point in the repeat playback
mode can be set using menu item No.163 [REPT
MODE].
When FREEZE is selected as the menu item
No.163 [REPT MODE] setting, the playback image
will not freeze properly if the tape end is set to
serve as the END point. Set the END point in a
section of the tape where images have been
recorded.
O If the counter display mode (TC/CTL) established
using the menu item No.161 [CTL (TC) BGN] or
No.162 [END] setting and the counter display mode
(TC/CTL) in which repeat playback is to be
performed do not correspond, the REPEAT lamp
flashes, and the repeat playback operation will not
be performed.
Select menu item No.161 [CTL (TC) BGN] or
No.162 [END], and press the DATA+ button
(PAUSE/STILL button) or DATA- button (PLAY
button).
<Note>
Whether a setting is to be entered can be
selected by operating the DATA+ button and
DATA– button.
The – –:– –:– –:– – display appears when there is
no setting. When repeat playback is performed
in this status, the BEGIN point serves as the tape
start and END point as the tape end.
2
Use the COUNTER button to select TC or CTL.
<Note>
When the RESET button is pressed, the display
is reset to 00:00:00:00.
3
Use the UP button (FF button) and DOWN
button (STOP button) to select the digit to be
changed (the one that is flashing).
The frame digits cannot be selected, and they
always appear as “00.”
4
The DATA+ button (PAUSE/STILL button) and
DATA– button (PLAY button) are used to
change the value displayed.
5
After performing the settings, press the SET
button (REC button).
The settings are now stored in the memory.
<Note>
If the MODE button (SEARCH) button is pressed
without first pressing the SET button after the
settings have been performed, the settings will
not be stored in the memory and the statuses
established prior to those settings will be
restored.
6
Set the LOCAL/MENU/REMOTE switch to the
LOCAL or REMOTE position.
7
Setting
Operation
OFF Normal operation
M-STOP
When the tape is fast forwarded or rewound, it
stops near the BEGIN point.
REPT1
When the tape is played back to the END point, it
is rewound to the BEGIN point where it stops.
CONT
When the tape is played back to the END point, it
is rewound to the BEGIN point and played back
again, and these operations are repeated.