Filter
Top Products
35
Setup menus
030 HD FREQUENCY
0000
0001
59/23
60/24
For setting the field frequency.
0: The field frequency is set to 59.94/23.98 Hz.
1: The field frequency is set to 60/24 Hz.
<Note>
The field frequency which is set here takes effect only when there is no input which
supports the OUT REF setting.
If there is an input which supports the setting, the field frequency is consistent with
the field frequency of input.
031 OUT REF
0000
0001
0002
0003
AUTO
INPUT
HD REF
SD REF
For selecting the video output reference.
0: The REF signal (HD/SD) which is input to the REF connector is automatically
identified and serves as the reference.
If no signal is supplied to the REF connector, the HD serial input signal serves
as the reference.
If neither the REF input signal nor HD serial input signal is supplied, the internal
sync signal serves as the reference.
1: The HD serial input signal serves as the reference.
If this signal is not available, the unit’s internal reference is used.
2: The HD REF input signal serves as the reference.
If this signal is not available, the unit’s internal reference is used.
3: The SD REF input signal serves as the reference.
If this signal is not available, the unit’s internal reference is used.
<Note>
When “1394” is selected as the menu item No.600 [VIDEO IN SEL] setting, the
output picture in the E-E mode or output picture during recording may be disturbed
in the vertical direction even when this item is set. However, there will be no
problem with the pictures which are recorded on the tape.
023 FORMAT SEL
0000
0001
0002
0003
0004
0005
0006
HD-LP
HD-SP
422
411
420p
DV
DVCAM
For selecting the format when MANUAL is selected as the menu item No.022 [PB
FORMAT] setting.
0: The DVCPRO HD-LP format is selected, and the format follows the menu item
No.020 [SYS FORMAT] setting.
1: The DVCPRO HD format is selected, and the format follows the menu item
No.020 [SYS FORMAT] setting.
2: The DVCPRO50 (422) format is selected.
3: The DVCPRO (411) format is selected.
4: The DVCPROP (420p) format is selected.
5: The DV format is selected.
6: The DVCAM format is selected.
“
” indicates the factory setting.
BASIC
Item Setting
No.
Superimposed
display
No.
Superimposed
display
Description of settings
020 SYS FORMAT
0000
0001
1080i
720p
For setting the format in which to record or play back the signals including the HD
REF signals.
0: 1080i mode
1: 720p mode
022 PB FORMAT
0000
0001
MANUAL
AUTO
For setting the format in which to play back the tape.
0: The tape is played back in the format selected by the menu item No.020 [SYS
FORMAT] setting.
1: The tape is played back in the format selected by the format in which the tape
was recorded.