Filter
Top Products
21
Basic Operation
Power ON / OFF
Always be sure to follow the procedure given below to turn the projection display power ON and OFF.
• The lamp cooling fan will continue to operate for approximately 1 minute after the power is turned off.
At the same time, the POWER indicator will blink Red.
Do not disconnect the power cord from the power outlet and do not open any circuit breakers while the
cooling fan is still operating.
Do not disconnect the power cord from the power outlet while the power indicator blinks Red.
Press the POWER button on the projection display or the
remote control to turn the power on.
The Power Indicator will become Green and blink for
approximately 10 seconds, and then turn solid Green.
The Power Indicator
LED ACTION
Notes:
• If the POWER button is accidentally turned off during use, after power is turned back on, it may take a short period
before the lamp automatically comes on.
• After the unit is turned on, maximum picture brightness will be achieved in 5-10 minutes. This is normal.
Power – OFF (Standby mode)
Power – OFF (Now cooling)
Power – ON
Power – ON (Preparing to light lamp)
Red
Red blink
Green
Green blink
Press the POWER button on the projection display or the
remote control to turn the power off. Confirming message
will appear.
Note:
When the AC Cord is unplugged, the internal cooling fan stops operating. In this case, the lamp will be insufficiently
cooled and will take a while to turn ON again.
Power ON
Power OFF
The Power Indicator will become Red and blink for
approximately 1 minute, and then turn solid Red.
Press the POWER button again.
Turning the Power ON and OFF
POWER button/
POWER indicator
If the POWER button is accidentally pressed, select NO
with the , buttons, then press the ACTION button.