11
AV IN
R L
AUDIO IN
L
R
VIDEO
AUDIO
AUDIO
IN
PC
S VIDEO
VIDEO
L
R
Y
P
B
P
R
P
B
P
R
Y
Y
PROGOUT
TO AUDIO AMP
COMPONENT VIDEO
INPUT
1
2
INPUT 2 INPUT 1
AUDIO
INPUT
VIDEO
INPUT
R
L
OUTPUT
AV IN
R L
AUDIO IN
S VIDEO
VIDEO
L
R
Y
VIDEO
AUDIO
P
B
P
R
P
B
P
R
Y
Y
PROGOUTCOMPONENT VIDEO
INPUT
1
2
INPUT 2 INPUT 1
TO AUDIO AMP
CableCARD
TM
ANTENNA
Cable In
DIGITAL
AUDIO OUT
G-LINK
AUDIO
IN
PC
L
R
OUTPUT
AUDIO OUT
L
R
OPTICAL IN
DIGITAL
AUDIO OUT
AUDIO INPUT
R
L
DIGIT
AL
AUDIO OUT
G-LINK
See optional equipment manual for further instructions for recording and monitoring.
Notes:
• Depending on your DVD player and DVD-Audio software the copyright protection function may operate and disable
optical output.
• External speakers cannot be connected directly to OUTPUT terminals.
• When ATSC channel is selected, the output from the DIGITAL AUDIO OUT jack will be Dolby Digital. When NTSC
channel is selected, the output will be PCM.
Optical digital audio cable
Audio cable
For a full Home Theater sound experience, an external Dolby Digital decoder and a multichannel amplifier must be
connected to the DIGITAL AUDIO OUT terminal on the TV.
Dolby Digital 5.1 channel surround sound delivers digital-quality sound. Dolby Digital provides five discrete full-
bandwidth channels for front left, front right, center, surround left and surround right, plus a LFE (Low Frequency
Effect) subwoofer channel.
Back of the TV
Notes:
• The input signals connected to INPUT1 cannot be output from PROG. OUT terminals. (both picture and audio)
However, output can be obtained from optical Digital Audio terminals.
(Input signals other than from INPUT1 can be output from PROG. OUT.)
• Connect the output of the Video recorder to INPUT1, when recording by using TV GUIDE.
• When a device (STB, DVD, etc.) is connected to the HDMI or COMPONENT terminals (see pages 12, 13), only audio
signals will be output. No video signals will be output.
• When a schedule recording is activated on the TV Guide, the show will be recorded on a connected VCR. Please
note that the screen will automatically be switched to the channel of the recorded show.
• When receiving digital channel signals, all digital formats are down-converted to composite NTSC video to be output
through Program Out terminals.
• Some programs contain a Macrovision signal to prevent VCR recording.
1. Select Speakers “Off” in Audio menu (see page 27).
2. Adjust the amplifier volume to the desired level.
Amplifier
or
VCR
AV cable
Back of the TV
DVD recorder
Connection
Program Out Connection (PROG OUT)
Amplifier Connection (TO AUDIO AMP)
Procedure